ICAD // Ref. Colour. Description. A. Black. –. Common Alarm. B. Brown. –. ICM fully open. C. Red. –. ICM fully closed. D. Orange. –. GND ground. E. 5a, ICM + ICAD A/ICAD A-TS mm in. H. L3. 1. ICAD A. Fig. 5b, ICM + ICAD A. Note: When mounting the. ICAD make sure to push. ICAD A / A actuators, for ICM motorised valves. Housing: part of ICAD: PBT thermo t temperature range: –30°C/+50°C.

Author: Zutaxe Mazucage
Country: Fiji
Language: English (Spanish)
Genre: Life
Published (Last): 23 February 2015
Pages: 143
PDF File Size: 12.71 Mb
ePub File Size: 10.40 Mb
ISBN: 642-6-97827-158-7
Downloads: 80494
Price: Free* [*Free Regsitration Required]
Uploader: Zulkirr

Magnet coupling must be protected.

Danfoss Refrigeration 027H0431

Manual operation is also possible with the actuator mounted on the valve and the power supply connected to the actuator. Do not open the valve while the valve is still under pressure.

I was very pleased with your service and would use you again. The spindle inside the valve must not be greased or danfpss fig. Drawings are only for illustration, not for dimensioning or construction. Check that the cone has been fully danfoss back towards the top cover before it is mounted in the valve body. Regin Valves And Controls. Henry Valve Sight Glasses and Driers.


The ICMTS valves are danfose to dismantle and all parts inside can be replaced by changing the function module. Danfoss Industrial Refrigeration reserves the right to make changes to products and specifications without prior notice. The Heart – ccbbiology. In cases of doubt, please contact Danfoss.

In order to treat you safely and effectively, please answer the. Delivery received yesterday in opened package, damaged box and partrs missing. For further information, please contact Danfoss.

Avoid welding debris and dirt in the valve body and the function module.

Danfoss Kp7abs High Pressure Switch. When installing an ICMTS, refrigerant sanfoss not be allowed to escape and dirt must not be allowed to enter the valve. The outlet side of the valve must always be connected to the system or properly capped off, such as the case with a welded-on end plate. It is important to remove the seat fig. Replacement of the function module – Remove the old module.

Use the manual magnetic tool fig. Danfoss Industrial Valves and Accessories. Use only original Danfoss parts, including o-rings and gaskets for replacement. Danfoss Solder Ball Valves. Maintenance Service A precise service schedule cannot be given for the valve as service intervals will depend on operating conditions, i.

Motor Operated Valves | Danfoss SG

ICMTS valves must not be mounted in systems where the outlet side of the valve is open to atmosphere. Why choose MyTub Limited for icad – actuator 2nd generation H? Please refer to the separate instruction manual on ICAD to address the manual function. The valve body must be free from stresses external loads after installation.


Remove all parts from the valve body before welding or soldering as shown in fig.

Overall, a great customer experience, I would not hesitate to recommend MyTub and the team to anyone. Insulation Insulating the valve and its actuator is only necessary if an energy consideration in the plant requires this. Documents Flashcards Grammar checker. The code number for the multi-function tool is H After welding, the external surface around the connections of the valve body must be protected to prevent against corrosion with a suitable coating.

Welding or soldering fig. If further corrosion protection is required, the valves can be painted. The valve is designed to withstand a high internal pressure. Danfoss Pm Main Valve f Allen Matthews – Glenammer Eng Ltd.