A microcontroller is a microprocessor and more. • Chip includes many 68HC11 I/O capabilities: 68HC11 has five I/O ports with up to 38 I/O pins depending on. nces, Books and Docs for 7. UTexas Homepage for Microcontroller courses. The procedure to load the file into the microcontroller is the following: a) At the prompt 6. References.
|Published (Last):||6 August 2005|
|PDF File Size:||5.79 Mb|
|ePub File Size:||17.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
LabView for Dummies http: I took readings from the lowest point we could reach and read which was 2 degrees C and then took reading at 5 degree intervals. Interrupts from BYU http: UTexas Homepage for Microcontroller courses.
68HC11 Temperature Measure and Display
UTexas Homepage for Microcontroller courses. This is a sample program used for EEL lab 1. To check and modify the parameters, follow the menu which pops up after you press: Also included in this objective was the task of designing software to do the following: In every 10 coours the hundredths digit is incremented and checked to see if it reaches Geocities Website for http: Timer and Interrupt Source code.
The display function can use OUTA routine from the buffalo program. To the right is the integrated op-amp that allows for the LM to supply a current and thus supply a voltage to the 68HC Cohrs were to scale the Temperature sensor to read from 0 to Celsius. Assemble again until there is no error.
To allow for consistent results we also included a mercury thermometer. Australian University Resources http: The LED lights connected to the Temperature readings was the easiest part of the coding. Procedure was to test the LM and record data off of the temperature reading of an ice bath that is gradually heated.
The output of the stopwatch should have four digits to display in format of wx. If the program couts properly, it displays: Figure 1 shows an accurate representation of the 68HC11 hardware. Timer and Interrupt Source code http: UNM howto on microcontrollers.
68HC11 Temperature Measure and Display – [DOCX Document]
SMU Microprocessors help pages. Interupts and Resets http: Driving a 7 segment dsiplay http: Interrupts intro short article http: UTexas Homepage for Microcontroller courses http: When the tenths digit reaches 10, it is reset to zero, and the ones digit is incremented. References, Books and Docs for http: When the interrupt occurs, and then CNTRL is changed to 1 stop or 2 resetlet program jump to the waiting loop. Hc11 resources and links.
Timers and Delays http: W, X, Y, and Z. Driving 7 segment display source code. The procedure to load the file into the microcontroller is the following: Timer and Interrupt Source code http: Short note on interrupt and handlers http: Turn in the following material.
Geocities Website for http: Interrupts from BYU http: